![image of captive guided version fitted with Rod-End Bearings For Captive-Guided Position Transducers](../images/dispacc/brgs1.jpg)
Rod-end bearings can be used with captive type transducers where there may be some mis-alignment
They should not be used horizontally if the transducer range is greater than ±100mm. For ranges larger than this you may wish to consider using our Mounting Block For RDP Transducers Mounting block.
They should not be used horizontally if the transducer range is greater than ±100mm. For ranges larger than this you may wish to consider using our Mounting Block For RDP Transducers Mounting block.
BRG1000
FEMALE
FEMALE
![logo for bearing 1000](../images/dispacc/brg1000.jpg)
![image of Rod-End Bearings For Captive-Guided Position Transducers](../images/dispacc/ol-brg1000.jpg)
TA = 11°
Mounting thread=M5x0.8,14mm
D1 = 16mm
ID = 4.987mm to 5.064mm
L = 27mm
L2 = 8mm
Maximum radiation dose=8k Gy
Operating temperature range=-34℃ to 104℃
Major construction material=Plated low carbon steel
BRG1001
MALE
MALE
![logo for bearing 1001](../images/dispacc/brg1001.jpg)
![image of Rod-End Bearings For Captive-Guided Position Transducers](../images/dispacc/ol-brg1001.jpg)
TA = 11°
Mounting thread = M5x0.8,20mm
D1 = 16mm
ID = 4.987mm to 5.064mm
L = 33mm
L2 = 8mm
Maximum radiation dose = 8k Gy
Operating temperature range = -34℃ to 104℃
Major construction material = Plated low carbon steel