RDP Home Page Banner
E309 Analogue Amplifier With Digital Display / Panel Meter

LVDT amplifier
Digital display module
Limit trips
Voltage / 4-20mA output
Simple trimpot controls
image of panel meter  E309 For LVDT Transducers
Signal conditioning is required where the output of a transducer needs to be boosted or changed into a form suitable for the monitor or logging device which will be used. Our digital display units have a built-in monitor device in the form of the digital display as well as analogue output.
The E309 has high and low limits with voltage-free relay outputs.
A very wide range of gain adjustment ensures that our amplifiers are compatible with the vast majority of LVDT sensors available from any manufacturer.
Although they have a digital display, these units are entirely analogue and are configured using switches and potentiometers, there is no set-up software to learn.
dimensional drawing of E30X
Panel cut-out = 139mm X 67mm
PMBH = 72mm
PMBH = 144mm
PMD = 185mm
PMDC = 245mm
PMHH = 67mm
PMHW = 139mm
Number of digits 4½, 11mm LED
Supply voltage 120/240V (+10/-20%), 50/60 Hz, 10VA
Output ±10V @5mA maximum
Output ripple 5mV typical
Output ripple (4-20mA output) 10uA typical
Analogue output bandwidth 300Hz
Transducer excitation 5V @100mA maximum, 5kHz (1 to 10kHz)
Limit trips:- number of channels 2
Limit trips:-Operation time 5ms
Limit trips:-Contact rating (maximum) DC 24V, 1A. AC 120V, 0.3AV
Linearity error ±0.1% F.S.
Temperature coefficient (zero) ±0.01% F.S. /℃ (typical)
Temperature coefficient (span) ±0.01% F.S. /℃ (typical)
Operating temperature range 0℃ to 55℃
Total weight 1.3kg

Do not use these products as safety, emergency stop or feedback devices in any application where the failure of this product could result in damage to equipment, personal injury or death.
Due to our policy of on-going development, specifications may change without notice. Any modification may affect some or all of the specifications for our equipment. All dimensions and specifications are nominal.