RDP Home Page Banner
Model RLS Single-Point Compression Load Cell

Very high accuracy
Infinite resolution
Low cost
dimensional drawing of  Model  RLS Single-Point Compression Load Cell
A load cell or force sensor is a device which converts load or force into an electrical signal.
A single-point compression load cell is designed for such applications as weighing scales.
Care should be taken to ensure that the load sensor is not exposed to load or force in excess of its capability. The range of compression load cell selected should therefore be appropriate for the maximum force (including transient forces) that can be applied to it.
This series of transducer is a strain gauge type transducer and has a mV output which may require an amplifier. We can offer a variety of high quality, low noise and high precision strain gauge amplifiers.
Compression load cell
A compression load cell measures the force applied to the load button.
dimensional drawing of  Model  RLS Single-Point Compression Load Cell
CD1=13.6mm
CD2=5.05mm ±0.15mm
CL1=22mm
CL2=27mm
Type Range A B C D E F G H Mounting thread
RLS005 5kgf (49N) 118mm 63.5mm 30mm 63mm 20mm 32mm 7mm 19.05mm M6, 25mm
RLS010 10kgf (98N) 118mm 63.5mm 30mm 63mm 20mm 32mm 7mm 19.05mm M6, 25mm
RLS020 20kgf (196N) 118mm 63.5mm 30mm 63mm 20mm 32mm 7mm 19.05mm M6, 25mm
RLS050 50kgf (491N) 118mm 63.5mm 30mm 63mm 20mm 32mm 7mm 19.05mm M6, 25mm
RLS100 100kgf (981N) 118mm 63.5mm 30mm 63mm 20mm 32mm 7mm 19.05mm M6, 25mm
Specification
Excitation/supply (acceptable) 0 to 15V
Excitation/supply (calibrated) 10V
Output 2mV/V ±10%
Zero balance 2% F.S.
Bridge resistance 350 Ω
Linearity error ±0.02% F.S.
Hysteresis ±0.02% F.S.
Repeatability ±0.02% F.S.
Resolution Infinite
Temperature coefficient (zero) ±0.0025% F.S. /℃ (typical)
Temperature coefficient (span) ±0.0025% F.S. /℃ (typical)
Operating temperature range -20℃ to 60℃
Compensated temperature range -10℃ to 40℃
Ingress protection (IP) 65
Over-range capacity 50%
Major construction material Aluminium alloy
Electrical termination 3m (integral cable)

Options and accessories

Due to our policy of on-going development, specifications may change without notice. Any modification may affect some or all of the specifications for our equipment. All dimensions and specifications are nominal.
www.rdpe.com/ex/rls.html
20190308