RDP Home Page Banner

Model LFH-7i Compression Load Cell

Stainless steel
Infinite resolution
image of Model  LFH-7i Compression Load Cell
Our SLC-LFH7I load cell or force sensor is a device which converts load or force into an electrical signal.
The SLC-LFH7I load cell should be mounted on a hard, flat surface. This compression load cell measures the compressive force applied between the top and bottom of the load cell.
Care should be taken to ensure that the model SLC-LFH7I load sensor is not exposed to load or force in excess of its capability. The range of model SLC-LFH7I compression load cell selected should therefore be appropriate for the maximum force (including transient forces) that can be applied to it.
The SLC-LFH7I transducer is a strain gauge type transducer and has a mV output which may require an amplifier. For the SLC-LFH7I we can offer a variety of high quality, low noise and high precision strain gauge amplifiers.
Compression Load Cell
Our SLC-LFH7I compression load cell measures the force applied to the load button.
dimensional drawing of  Model  LFH-7i Compression Load Cell
Type Range D1 H D2 H2
SLC-LFH7I00250 250lbs (1.1kN) 12.7mm 9.7mm 6.9mm 3.3mm
SLC-LFH7I00500 500lbs (2.2kN) 12.7mm 9.7mm 7.1mm 3.3mm
SLC-LFH7I01000 1000lbs (4.4kN) 12.7mm 9.7mm 7.9mm 3.3mm
SLC-LFH7I02000 2000lbs (9kN) 12.7mm 9.7mm 10.4mm 3.3mm
SLC-LFH7I03000 3000lbs (13kN) 12.7mm 9.7mm 11.4mm 3.3mm
SLC-LFH7I05000 5000lbs (22kN) 16.0mm 15.2mm 13.5mm 5.8mm
SLC-LFH7I07500 7500lbs (33kN) 22.4mm 16.0mm 16.0mm 13.7mm
SLC-LFH7I10000 10000lbs (44kN) 22.4mm 16.0mm 16.0mm 13.7mm
Excitation/supply (calibrated) 5Vdc
Bridge resistance 350 Ω
Accuracy ±0.70% F.S.
Resolution Infinite
Temperature coefficient (zero) ±0.018% F.S. /℃
Temperature coefficient (span) ±0.02% rdg /℃
Operating temperature range -54℃ to 121℃
Compensated temperature range 16℃ to 71℃
Deflection at full scale 1.02mm maximum
Over-range capacity 50% F.S.
Major construction material stainless steel
Electrical termination 1.5m (integral cable)

Options and accessories