RDP Home Page Banner

S7M 115/230V ac powered LVDT transducer amplifier.


LVDT amplifier
High environmental protection
Voltage / 4-20mA output
Simple trimpot controls
image of S7M 115/230V ac powered LVDT transducer amplifier.
Signal conditioning is required where the output of a transducer needs to be boosted or changed into a form suitable for the monitor or logging device which will be used. These amplifiers are suitable for LVDT transducers.
Our S7 amplifiers are specifically designed to be installed close to the transducer so that the signal can be boosted as soon as possible. The S7 signal conditioning units are mounted in a die-cast aluminium housing and have a good level of environmental protection and screening from electrical noise.
A very wide range of gain adjustment ensures that our amplifiers are compatible with the vast majority of LVDT sensors available from any manufacturer.
dimensional drawing of S7
A=8.66''
B=8.03''
C=4.72''
D=3.23''
E=3.19''
F=0.24''
Cable gland cable size (x1) = 0.20'' to 0.35''
Cable gland cable size (x2) = 0.12'' to 0.26''
Compatible with any standard RDP LVDT (without integral electronics) LIN & PY When fitted with two 1k Ohm bridge completion resistors ( Does not provide analogue voltage linearisation for PY) Most LVDTs from any manufacturer
Specification
Supply voltage 115/230V, 50/60Hz, 2.5VA
Output 1 ±10V
Output 2 4 to 20mA (loop resistance 0Ω to 600Ω)
Output ripple 5mV peak-to-peak typical
Approximate zero adjustment range ±10V
Analogue output bandwidth 500Hz
Signal input range 0.02V to 20V (minimum)
Amplifier gain range 0.15 to 200
Transducer excitation 5V, 5kHz, 100mA maximumkHz
Linearity error ±0.1% F.S. maximum
Temperature coefficient (zero) ±0.001% F.S. /℉ typical
Temperature coefficient (span) ±0.002% F.S. /℉ (typical)
Operating temperature range 14℉ to 122℉
Total weight 4.0lb